INITIAL SETUP
REMOVAL
DISASSEMBLY
TM 10-4610-232-34
2-27. PRESSURE SWITCH PANEL ASSEMBLY. This task covers: (MODEL WTA-060 ONLY)
a. Removal.
b. Disassembly.
C. Repair.
d. Reassembly.
e. Installation.
Tools, see TM 10-4610-232-12, Appx B,
Sec Ill, Ref Code (No.):
Tool Kit, General Mechanics Automotive (1)
Materials/Parts:
Tape. Antiseize (Appx B, Sec II, Item 67)
Tags
Preformed Packing (TM 10-4610-232-24P)
Equipment Condition:
ROWPU shutdown. Pressure switch panel junction
box removed (para. 2-28). Main circuit breaker
(CB1) turned OFF.
General Safety Instructions:
WARNING
Observe specific Warnings in the text.
WARNING
Make sure electrical power is disconnected before working on unit. Failure to do so
could result in serious injury or death from electrical shock.
WARNING
Do not wear watches, rings, or dog tags when working on electrical components.
WARNING
Make sure air pressure is vented from manifolds before working on switch panel
assembly. Failure to do so could result in serious injury from pressurized air.
NOTE
Tag all wires before disconnecting to make installation easier.
a. Shut off electrical power by turning main circuit breaker CB1 (1, Figure 2-39, sheet 1) to the OFF position.
Disconnect cable P24.
b. Close air tank valve (2) and open manifold bleed valve (3) to drain air pressure in the system.
c. Check air pressure gages (4) to ensure that air pressure in the system is zero.
d. Tag and disconnect seven hoses (5 thru 11) by unscrewing hose nuts at the points where they connect to their
respective pressure switches.
e. Refer to Figure 2-39, sheet 2, remove four capscrews (12), lockwashers (13) and washers (14) and remove the
pressure switch panel as an assembly.
a. Unscrew the hose nuts on each end of tube (15) and remove the tube. Remove tubes (16, 17 and 18) in the same
way. Tee (23) is now free.
b. Remove seven pressure switches (28 thru 33 and 34) as follows:
(1) Remove capscrews (19), lockwashers (20) and washers (21).
Change 3
2-145
