TM 10-4610-232-34CAUTIONThe projection on the bottom of retainer must pass through springs and through thehole in plate. The valve will not operate if this is not done and maintained duringassembly.ab. Assemble plate (15), springs(13 and 14) and retainer (12).ac. Install capscrew (11). Tighten to 35-40 ft. Ibs. (47-54 Nm).ad. Install new preformed packing (10) in valve cover (9). Use glycerine to hold the preformed packing in place whileinstalling cover.CAUTIONBe careful to keep the valve cover clamp level on the valve covers by tightening eachnut alternately and evenly the same amount.ae. Install valve cover clamp (8) with washers (7) and nuts (6). Tighten the nuts (6) to 200 ft. Ibs. (271 Nm).INSTALLATION.CAUTIONUse extreme care to avoid damage to drain valves during installation.a. Using a suitable lifting device, rig a lifting sling and place the pump on its mounting brackets in the frame.b. Install four capscrews (5), washers (4), washers (3), Iockwashers (2) and nuts (1).2-254
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
