TM 10-4610-232-34
3-3. ISO CONTAINER. This task covers:
a. Removal.
b. Repair.
c. Installation.
Tools, see TM 10-4610-232-12, Appx B,
Sec Ill, Ref Code (No.):
Tool Kit, General Mechanics Automotive (1)
Lifting Device (10 Ton Capacity)
Drill with Drill Bits (4)
Rivnut Repair Kit (15)
Materials/Parts:
Caulk (Appx B, Sec II, Item 9)
Rivets (Appx B, Sec II, Item 59)
Lockwashers (TM 10-4610-232-24P)
Washers (TM 10-4610-232-24P)
Wire Ties (Appx B, Sec II, Item 71)
Personnel Required: 3
Equipment Condition:
ROWPU shut down. High pressure pump assembly
removed (para. 2-67).
Generator removed (para. 2-86).
General Safety Instructions:
WARNING
Observe specific Warning in text.
REMOVAL.
a. Remove twenty four capscrews (1, Figure 3-2, View A), Iockwashers (2) and washers(3) and remove lifting sling
access panel (4).
b.
c.
d.
e.
Remove lifting sling (5) from mounting bracket in container.
WARNING
Do not operate lifting device without safety latches on hooks. Failure to do so may
result in serious injury.
CAUTION
Do not twist straps on sling when hooking to van.
Connect sling hooks (6, View B) to corner blocks (7) with hook facing out away from van.
Remove nylon wire tie (8, View C) connecting the shackle pin (9) to the van,
Turn the shackle pin (9) one quarter turn clockwise and remove.
WARNING
Container weighs over 7 tons. Using an unsuitable lifting device may result in serious
injury.
CAUTION
The container will not lift up evenly. The right front corner will be lower. Failure to be
aware of this may result in serious damage.
f. Slowly lift container off trailer using two personnel to guide the van.
g. Push locking pin (10, View D) up and turn mounting shackle (11) until tabs are lined up with mounting holes Lift
up and remove.
a. Locate rivets (1, Figure 3-3) under rain gutter (2) and mark location.
Change 1 3-5
