TM 10-4610-232-34
b.
c.
d.
e.
f.
g.
h.
NOTE
Grind only enough to remove and install rivets as shown on View A of Figure 3-3.
Grind away rain gutter at location of rivet only.
Drill out rivets (1) and remove skin (3).
Remove old caulking.
Replace damaged insulation.
Place new skin (3) on van to see if holes in skin align with holes in van. Then remove.
Install caulking on frame.
Install skin and secure with rivets (1) starting at the top and working down.
i. Repeat steps c through h for replacing skins on doors, access panels and roof.
WARNING
Do not operate lifting device without safety latches on hooks.
CAUTION
Do not twist straps on sling when hooking to van.
a. Connect sling hooks (6, Figure 3-2) to corner blocks (7) with hook facing out away from van.
b. Line up mounting shackle teeth (12, View D) with mounting hole (13) in trailer.
c. Insert mounting shackle(11) then make one quarler turn counterclockwise. Push locking pin(10)down secure
mounting shackle.
WARNING
Container weighs over 7 tons. Use a suitable lifting device to prevent serious injury.
CAUTION
The container will not lift up evenly. The right front corner will be lower. Failure to be
aware of this may result in serious damage.
d. Using two personnel, guide container onto trailer. Slowly lower container into place on mounting shackle (11).
e. Take shackle pin (9) and insert into mounting shackle (11), then rotate one quarter turn counterclockwise
f. Secure shackle pin (9) to trailer with nylon wire tie (8) as illustrated in View C.
g. Coil cable and secure underneath trailer frame with nylon wire tie as illustrated in View C.
h. Remove lifting sling hooks (6) from container corner blocks
i. Store lifting sling (5) back in container on mounting bracket and secure with straps on storage rack.
j. Install lifting sling access panel (4) and secure with twenty four capscrews (1), Iockwashers (2) and washers (3).
3-8 Change 1
