TM 10-4610-239-24
TM 08580B-24/3
REMOVAL.
a.
Remove four nuts (1), four screws (2), clamp halves (3), two gaskets (4), and adapters (5) from
R.O. pump (6) and two pipe sections (7).
b.
Loosen hose clamp (8) and remove water hose (9).
c.
Remove four nuts (10), lockwashers (11), and screws (12) from pump stand (13) and R.O. pump
(6). Discard lockwashers.
WARNING
Weight of R.O. pump is 658 pounds (298 kg). Attempting to move it
without proper equipment could cause serious injury. Hoist pump with
equipment rated at 1 ton or greater.
d.
Using lifting equipment, remove R.O. pump (6).
INSTALLATION.
a.
Position R.O. pump (6) on pump stand (13), align mounting holes, and install four screws (12),
new lockwashers (11), and nuts (10).
b.
Install water hose (9) and tighten clamp (8).
NOTE
Apply antiseize tape to male pipe threads before installation.
c.
Install two adapters (5) on R.O. pump (6).
d.
Install two gaskets (4) on adapters (5) and pipe sections (7).
e.
Position two clamps (3) over gaskets (4) and install four screws (2) and nuts (1).
f.
Install R.O. pump oil drain valve and air breather. Refer to paragraph 2-126.
g.
Install R.O. pump oil gage. Refer to paragraph 2-127.
h.
Install R.O. pump assembly sheave. Refer to paragraph 2-125.
i.
Refill R.O. pump assembly with oil. Refer to LO 10-4610-239-12/LI 08580B-12.
2-311
