TM 10-4610-239-24
TM 08580B-24/3
REMOVAL. (Cont)
c.
Remove nut (8) and lockwasher (9).
d. From front of control box assembly, remove lens (10), gasket (11), and bulb (12).
e. Remove lampholder (7) and rubber washer (13) from control box assembly (14).
f. Close control box cover (4) and install but do not tighten 14 screws (1), lockwashers (2), and flat
washers (3).
INSTALLATION.
NOTE
There are nine lampholders. All are installed the same. One is shown.
a. Remove 14 screws (1), lockwashers (2), and flat washers (3). Lower control box cover (4).
b. Position lampholder (7) with rubber washer (13) on control box assembly (14).
c.
Install bulb (12), gasket (11), and lens (10).
d. From inside control box assembly, install lockwasher (9) and nut (8).
e. Install three wires (6) as tagged and two screws (5).
f. Close control box cover (4) and install but do not tighten 14 screws (1), lockwashers (2), and flat
washers (3).
3-170
