ARMY TM 10-4610-309-14
MARINE CORPS TM 10802A-14/1
0028 00
TACTICAL WATER PURIFICATION SYSTEM (TWPS)
OPERATOR INSTRUCTIONS
PREPARATION FOR MOVEMENT ARMY UNIT
Preparing to Load the A-TPWS on a PLS Trailer
If the A-TWPS is to be loaded onto a PLS Trailer, rollers are installed on the flat rack so that the A-TWPS
can be rolled onto the trailer. After the A-TWPS has been loaded onto the PLS truck, install the flat rack
rollers as follows:
1. Remove both rollers from their storage brackets at the bail bar end of the flat rack as follows (see
Figure 29):
a. Remove the retaining pins.
b. Pull out the roller axle.
c. Lift the roller out of the storage bracket.
2. Install both rollers in their in-use brackets at the operator station end of the flat rack as follows
(see Figure 29):
a. Position the roller in the in-use bracket.
b. Slide the roller axle through the bracket and roller.
c. Insert a retaining pin in both ends of the axle.
Once the rollers are installed, the A-TWPS can be lifted by the bail bar using the arm on the PLS truck
and rolled onto an attached PLS trailer.
IN-USE
BRACKET
RETAINING PIN
AXLE
ROLLER
STORAGE
BRACKET
Figure 29. Flat Rack Roller Installation.
END OF WORK PACKAGE
0028 00-39/40 BLANK
