TM 10-4610-310-14
0131 00
REMOVAL - continued
Figure 2. Chemical module Junction Box Assembly.
1. Loosen four screws (5) from the cover and remove the cover (7).
2. Remove the wiring from the terminal block inside the junction box. Note the location of the wires and their
numbers.
3. Remove chlorine pump conduit from hub (1).
4. Remove control panel cable from hub (4).
5. Remove antiscalant pump conduit from hub (9).
6. Remove coagulant pump from hub (6).
7. Remove four screws (8), nuts (3), and washers (2) from junction box. Remove the junction box.
8. Remove end stops from the mounting rail and Pry off the terminal block from the mounting rail. See
Figure 3.
TERMINAL
BLOCK
Figure 3. Terminal Block.
