TM 5-3800-205-10-2
OPERATION UNDER USUAL CONDITIONS - CONTINUED
0005 00
OPERATE MACHINE - CONTINUED
2.
Operate Machine--Sequence Checklist.
a.
Perform initial adjustments, daily checks, and EMS self-test.
b.
Start engine.
c.
Repeat EMS self-test and perform engine warmup.
d.
Turn on appropriate machine lights.
e.
Raise tank high enough to clear any obstacles on ground.
f.
Depress service brake pedal to prevent machine movement.
g.
Release parking brake.
h.
Unlock shift lever lock.
i.
Move transmission shift lever to desired direction and appropriate gear speed.
j.
Release service brakes.
k.
Depress accelerator pedal to achieve desired engine speed.
l.
Check instrument panel gages and EMS lights frequently during operation.
STOPPING/PARKING MACHINE
NOTE
Refer to WP 0004 00 for the location and operation of controls.
1.
Apply service brakes to stop machine. Select a level surface if possible.
2.
Move transmission shift lever to N (Neutral).
3.
Lock shift lever lock.
4.
Apply parking brake.
5.
Lower tank to the ground. Apply slight downward pressure to tank.
6.
Block wheels securely.
ENGINE SHUTDOWN
CAUTION
Stopping engine immediately after it has been operating under a load can result in overheating and
accelerated wear of engine components.
The following shutdown procedures allow engine to cool. This will prevent excessive temperatures in
turbocharger center housing. Failure to shut down engine properly may cause oil sludge problems.
1.
Run engine at low idle for five minutes.
2.
Turn off machine lights and accessories.
3.
Turn ignition switch counterclockwise to OFF position. Remove key from switch.
AFTER OPERATION
1.
Perform After operation PMCS.
2.
Place battery disconnect switch to OFF position. If operation is not anticipated for an extended period of time, remove
key from switch.
3.
Secure machine against vandalism, as required, using padlocks (Item 11, Table 2, WP 0023 00) on the following:
0005 00-8
