TM 5-3800-205-23-3
WATER HOSE ASSEMBLIES, INLET/OUTLET PIPES, AND
MANIFOLDS REPLACEMENT - CONTINUED
0035 00
HOSES ASSEMBLY INSTALLATION
1.
Lubricate with grease and install new gasket (9) on each end of hose (5).
2.
Lubricate with grease and install new O-ring (8) in elbow (7).
3.
Connect hose (5) to manifold assembly (6).
4.
Install, but do not tighten, other end of hose (5) on elbow (7).
5.
Position elbow (7) and hose (5) at tank flange and install four bolts (4), eight flatwashers (3), four new lockwashers (2),
and nuts (1).
6.
Tighten elbow end of hose (5).
LOWER PIPE REMOVAL
1.
Remove hose reel assembly and mounting plate (WP 0030 00).
2.
Remove two nuts (10), bolts (11), coupling (12), and seal (13) from both ends of lower pipe (14).
3.
Remove two seals (13) and lower pipe (14).
4.
Inspect seals (13) for dry rot, cracks or tears. If damaged, replace seals.
12,13 (HIDDEN)
14
10,11
10,11
12,13 (HIDDEN)
LOWER PIPE INSTALLATION
1.
Install two seals (13) and lower pipe (14).
2.
Install coupling (12) on each end of lower pipe (14) with two bolts (11) and nuts (10).
3.
Install hose reel assembly and mounting plate (WP 0030 00).
0035 00-4
