TM 5-3800-205-23-3
WATER PUMP HYDRAULIC MOTOR REPLACEMENT - CONTINUED
0037 00
INSTALLATION
NOTE
Ensure all mounting hardware is removed from old motor and assembled onto new hydraulic motor.
Lubricate new O-rings with oil prior to installation.
1.
Install new O-ring (18) in flange of water pump bearing housing (10).
2.
Install coupling (17) on hydraulic motor shaft (16).
3.
Install support bracket (11) to hydraulic motor (2) with two new lockwashers (15) and nuts (14). Do NOT fully tighten
nuts.
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Failure to follow this warning may result in injury or death to personnel.
NOTE
Hydraulic motor weighs 55 lb (25 kg).
4.
With assistance, install hydraulic motor (2) on studs (7).
5.
Install four new lockwashers (9) and nuts (8) to secure hydraulic motor (2) and tighten.
6.
Tighten two lockwashers (15) and nuts (14) to support bracket (11).
7.
Install two new lockwashers (13) and bolts (12) to support bracket (11) and frame.
8.
Fill water pump bearing housing (10) with oil (Refer to Unit PMCS in TM 5-3800-205-23-1).
10
8,9
7
8,9
7
2
14,15
11
12,13
0037 00-5
