Rotor Set Component Assembly Procedure
place housing in
1.
Place housing (15) in a vise per
vise
MAF motor assembly procedure
#9 and FIGURE 39 (Page 18).
place wearplate &
2.
Place wearplate (7) and then
stator on housing
stator (6B) on the housing (15)
and align the bolt holes of the
three parts.
insert two bolts
3.
Insert two bolts (2) into bolt holes
finger tight, approximately 180°
apart to retain the stator (6B) and
wearplate (7) stationary on the
housing (15). SEE FIGURE 59.
assemble six
4.
Assemble the rotor (6A) into the
stator vanes &
stator (6B) with six vanes (6C) or
rotor
as many vanes that will readily fit
into the stator vane pockets. SEE
FIGURE 60 and 61.
NOTE
NOTE: A special tool (See Page
7A) or the drive link (8) held in
large locking pliers between two
rods or nails to protect the drive
link splines (SEE FIGURE 62) will
be required to rotate the rotor in
the following procedure.
23