insert seal ring
20.
Apply a small amount of clean
grease to a seal ring (5) and insert
the seal ring into the end cover
(3) seal ring groove. SEE FIGURE
54.
install end cover
21.
Install end cover (3) assembly on-
to the rotor set (6) with seal ring
(5) against the stator (6B) and
align the end cover bolt holes with
the stator (6B) bolt holes. SEE
FIGURE 55.
install & torque
22.
Install 7 bolts (2) into the
bolts
assembly bolt holes finger tight,
then torque the bolts to 22-26
foot pounds, (30-35Nm), in the
sequence shown, using the
appropriate torque wrench. SEE
FIGURES 56, 57 and 58.
The assembly of the MAF Torq-
motorTM is now complete, except
for the woodruff key (1), port
manifold o-rings (21) or nut (22),
if required, at TorqmotorTM
installation. See Page 25 for final
checks.
22