install drive link
14.
Install either end of the drive link
(8) through the commutator (9)
cavity and engage the lower drive
link splines into mesh with the
internal splines in the coupling
shaft (11). SEE FIGURE 46. A
spline valley on both ends of the
drive link will now be in line with
the commutator drive pin (10) and
coupling shaft timing mark.
insert seal ring into
15.
Apply a small amount of clean
housing
grease to a new seal ring (5) and
insert the seal ring into housing
(15) seal ring groove. SEE FIGURE
47.
insert seal ring into
16.
Place assembled rotor set (6) on a
stator
clean work surface with the stator
(6B) seal ring groove up. Apply a
small amount of clean grease to a
new seal ring (5) and insert the
seal ring into the stator (6B) seal
ring groove. SEE FIGURE 48.
place wearplate on
17.
Place wearplate (7) either side up,
rotor set
onto the rotor set (6) and align
wearplate bolt holes with the
stator (6B) bolt slots. SEE FIGURE
49.
20