assemble seventh
5.
Rotate the rotor (6A) using the
stator vane
tool described above to seat the
rotor and assembled vanes (6C)
into the stator (6B) and to create
necessary clearance to assemble
the seventh or full complement of
seven vanes. Assemble the seven
vanes using minimum force. SEE
FIGURE 63.
CAUTION
CAUTION: Too much force used
to push the rotor vanes into place
could shear off the coating applied
to the stator vane pockets. Use
care during this procedure to pre-
vent damage to rotor set and the
drive link splines, if you use your
drive link as the assembly tool as
shown in FIGURE 63.
remove tool, bolt,
6.
Remove drive link tool, the two
rotor set &
bolts, then the assembled rotor
wear plate
set (6) and wearplate (7) as a unit
from the housing and set them
aside for subsequent TorqmotorTM
assembly procedures. SEE FIGURE
64.
NOTE
NOTE: Go to the notes preceding
Step 10 of the MAF Assembly
Procedure if the MAF Assembly
Procedure was interrupted after
MAF Assembly Step 9, to assem-
ble the rotor set.
24
