Fuel Injection Pump Housing And Governor - TM-55-1930-209-14P-9-2

Remove Fuel Injection Pump Housing And Governor -cont

TM-55-1930-209-14P-9-2 Water Purification Barges (NSN 1930-01-234-2165) Fuel Oil System Manual
Page Navigation
293

Engine Disassembly and Assembly Fuel Injection Nozzles 3. Install a new seal (2) on fuel injection nozzle (1). 4. Put carbon dam seal (3) on the small end of tool (C), and expand it by sliding it to the large end. Put tool (C) against the fuel injection nozzle, and slide carbon dam seal (3) off tool (C) on to the nozzle. Slide the carbon dam seal into position in the groove on the nozzle as shown. 5. Put fuel injection nozzle (1) in position in the cylinder head. Install clamp (5) and bolt (4) to hold the nozzle in position. END BY: a. install fuel injection lines Fuel Injection Pump Housing And Governor Remove Fuel Injection Pump Housing And Governor 1286-011 Tools Needed A 8S2264 Puller Group 1 8B7560 Step Plate 1 1A2116 Bolt [3/8"-24 NF x 5 in. (127 mm) 2 long] 5P1075 Washer 2 START BY: a. remove fuel injection lines b. remove fuel filter and base c. remove fuel transfer pump NOTE: The following illustrations are of a 3304 Engine. 1. Disconnect the governor control linkage from the governor control group. 2. On 3304 Engines only: remove oil supply line (1), oil drain line (2) and heat shield (3). Remove the O-ring seal from oil drain line (2) if it is damaged. Remove the gaskets. Remove the screen from the top of the turbocharger. 3. Disconnect fuel drain lines (5) and (6) from the fuel injection pump housing and governor. 4. Remove switch (4) and the bracket from the governor. If necessary, remove governor control group (7) from the governor. 12

Privacy Statement
Press Release
Contact