Engine
Disassembly and Assembly
Fuel Injection Pump Housing And Governor
15.
Install the gasket, cover (17) and the bolts that
hold it.
16.
Connect fuel drain lines (16) and (20).
17.
Install heat shield (18).
18.
On 3304 Engines, install the strainer assembly in
the turbocharger with the screen down. Install the
gasket, oil inlet line (14) and the bolts that hold them.
Install the O-ring seal on oil drain line (15). Put clean
engine oil on the O-ring seal. Install the gaskets, oil
drain line (15), the elbow and the bolts that hold them.
Install the clamp that holds the oil lines together.
19.
Install switch (19) and the bracket on the
governor.
20.
If it was necessary to remove governor control
group (21), install the governor control group.
21.
Connect the governor control linkage to the
governor control group.
END BY:
a.
install fuel transfer pump
b.
install fuel filter and base
c.
install fuel injection lines
Governor
Disassemble Governor 1264-015
Tools Needed
A
B
C
1P510
Driver Group
1
1P1855 Retaining Ring Pliers
1
6V2163 Compressor Clamp*
1
*Part of 6V4095 Pump And Governor Reconditioning
Tool Group
START BY:
a.
remove
fuel
injection
pump
housing
and
governor
NOTE: If it is desired to remove only the governor so the
fuel injection pump housing can be disassembled, do
only Steps 1, 2, 15, 21, 25, 26, 27, 28, 31, 33, 34 and 37.
1.
Remove bolts (1), the clamps and service meter
(2).
2.
Remove six bolts (3), two top bolts (4), housing
(5) and the gasket.
16