Engine Disassembly and Assembly Camshaft Bearings 3.   Install   the   camshaft   bearings   in   the   3306   cylinder block as follows: a. Install the front bearing to a depth of 0.5  +  0.5  mm  (.02  i  .02  in.)  and  with  the  oil  holes  in  a horizontal position and the joint at the top of the engine. The joint can not be more than 15° from vertical in either direction. b. Install the remainder of the bearings with the oil holes in alignment with the oil holes in the cylinder block. Install the bearings to the dimensions given from the front face of the cylinder block: A) 154.0 + 0.5 mm (6.06 + .02 in.), B) 303.2 + 0.5 mm (11.94 i  .02 in.), C) 601.7 + 0.5 mm (23.69 + .02 in.), D) 903.4 + 0.5 mm (35.57 +  .02 in.). END BY: a. install camshaft b. Install flywheel housing c. install oil pan plate Crankshaft Remove Crankshaft 1202-011 Tools Needed A B C OTC Model 1750A Engine Repair 1 Stand 5P9736 Link Bracket 1 6V2157 Link Bracket 1 8B7551 Bearing Pulling Attachment 1 8B7549 Leg 2 3H465 Plate’ 4 1B4207 Nut’ 2 8B7560 Step Plate 1 1P820 Hydraulic Puller Group 1 6V9061 Hand Pump (or electric) 1 'Part of 8B7548 Push-Puller. START BY: a. remove flywheel housing b. remove timing gear cover c. remove oil pan plate d. remove oil pump NOTE: The procedure for crankshaft removal is the same on both 3304 and 3306 Engines. The illustration in the procedure which follows is of a 3306 Engine. 1. Install the engine on tooling (A) with the crankshaft in a horizontal position and on top. 2. Turn the crankshaft until the timing mark "C" on crankshaft gear (1) is in alignment with the timing mark "C" on camshaft gear (2) as shown in the inset. 114