Engine
Disassembly and Assembly
Flywheel
Install Flywheel 1156-012
Tools Needed
A
FT120
Lifting Bracket
1
NOTICE
The ring gear must be installed with the chamfered side
of the teeth up as shown in the inset of illustration
A89844X1. This will put the chamfered side of the gear
teeth toward the starter when the flywheel is installed so
the starter will engage correctly.
1. Heat ring gear (1) to a maximum temperature of
3200C (6080F). Install the ring gear on the flywheel.
2.Install tooling (A) on the flywheel in the same position it
was during removal.
NOTE: Install two 5/8"-18 NF guide bolts in the
crankshaft if necessary.
3. Make an alignment of timing mark (2) on the
crankshaft and timing mark (3) on. The flywheel. Hold
the flywheel in position, and install the bolts that hold it to
the crankshaft. Tighten the bolts to a torque of 205 + 27
N* m (151 + 20 Ib.ft.).
122