TM 10-4320-317-13
3-5.
MAINTENANCE OF HOSE ASSEMBLIES. - (Cont)
2
Inspect for missing or damaged O-rings (4) on adapter (5). Replace missing or damaged O-rings (4).
3
Apply anti-seize lubricant to O-rings (4).
4
Insert hose ends (6 and 7) between clamps (3) and onto adapter (5).
CAUTION
Do not overtighten nuts and bolts. Overtightening may damage O-rings and adapter causing leaks.
5
Tighten nuts (1) and bolts (2) alternately and evenly. Do not overtighten.
(2)
Install grooved end adapter assembly onto end of collapsible hose assembly as follows (Figure 3-4):
Figure 3-4. Grooved End Hose Adapter Assembly
NOTE
Always mark, score, and cut hose squarely. Do not leave ragged or uneven edges.
(a) Cut end of hose (1) below damaged section. Remove damaged hose end (2).
(b) Inspect inside of hose end (3) for further damage. Cut hose back again, as required, to reach an undamaged
area.
(c) Drain hose end (3) and wipe dry.
3-7
