TM 10-4610-215-24
TM 08580A-24/2
(5) Press pump-end bearings (21 ) on rotor shaft (18).
(6) Install bearing-lock ring (20) on rotor shaft (18).
(7) Install new seal (19) in pump-end plate (16).
(8) Install rotor shaft (18) in pump-end plate (16).
(9) Install four screws (17) through pump-end plate (16) and bearing cover plate (22).
CAUTION
Motor casing wiring can be snagged or broken by rotor shaft.
Take care not to damage wires when installing pump--end plate
and rotor shaft.
(10) Align prepunched indexing marks on pump-end plate (16) and motor casing (25).
(11) Install pump-end plate (16) with rotor (18) attached, in motor casing (25).
(12) Install wavy washer (14) on rotor shaft (18).
(13) Align prepunched indexing marks on fan-end plate (13) and motor casing (25).
(14) Insert four through bolts (12) through fan-end plate (13), motor casing (25), and pump-end plate (16)
and install four nuts (11).
(15) Spread clamp of cooling fan (9) and slide over rotor shaft (18).
(16) Tighten clamp bolt (10) on hub of cooling fan (9).
(17) Install fan cover (8) on fan-end plate (13).
(18) Install three screws (7) through fan cover (8) and fan-end plate (13).
(19) Install shaft key (15), if previously removed, in rotor shaft (18).
NOTE
Secure shaft key in place with tape, wire, or similar method to
avoid loss.
(20) Hold conduit box (5) and gasket (6) in place on motor casing (25) and align two mounting holes.
3-38
