TM 10-4610-229-24
2-79. INSTRUMENT PANEL ASSEMBLY REPAIR (CONT)
8
Remove bolt from engine. Install bolt in temperature sensor line clip. Install bolt in cylinder block.
9
Install lower rear cover. Install bolt, flatwasher, and nut. Install two lockwashers, screws, and nuts.
10
Connect battery (para 2-16).
c.
Ammeter Replacement
1
Remove nut, bolt, and flatwasher. Remove two screws, nuts, and lockwashers. Remove lower rear cover.
WARNING
To prevent electric shock, make sure battery is disconnected before performing this procedure.
2
Tag three wires. Remove two nuts and lockwashers. Remove wires and fiber bracket.
3
Pull ammeter through front of panel.
4
Install ammeter and fiber bracket. Install three wires. Install two lockwashers and nuts. Remove tags.
5
Install lower rear cover. Install bolt, flatwasher, and nut. Install two lockwashers, screws, and nuts.
6
Connect battery (para 2-16).
2-203
