TM 10-4610-229-24
2-78. INSTRUMENT PANEL REPLACEMENT (CONT)
4
Remove elbow from back of oil pressure gage.
5
Remove bolt from clip securing temperature sensor line.
6
Remove temperature sensor line from adapter on cylinder block. Install bolt in engine.
7
Remove elbow from back of fuel pressure gage.
8
Remove two bolts, two washers, and two spacers.
9
Remove instrument panel assembly from engine.
b.
Installation
1
Aline holes on instrument panel assembly bracket and engine. Install two spacers, flatwashers, and bolts.
2
Install elbow on back of fuel pressure gage.
3
Install temperature sensor line in adapter on cylinder block.
4
Remove bolt from engine. Install bolt in temperature sensor line clip. Install bolt in engine.
5
Install elbow on back of oil pressure gage.
6
Connect wiring on all gages, switches, and utility lamp. Solder as required. Remove tags.
7
Install lower rear cover. Install bolt, flatwasher, and nut. Install two lockwashers, screws, and nuts.
8
Install upper rear cover. Install two lockwashers and screws.
9
Connect battery (para 2-16).
2-200
