TM 10-4610-229-24
2-81. HOUSING AND V-BELTS REPLACEMENT/REPAIR (CONT)
4
Release pressure. Look at pressure scale reading under 0-ring.
5
Repeat steps 1 thru 4 for rear belt.
6 Both readings should be 21-25 lb (9.5-11.25 kg) and within 1 lb (0.45 kg) of each other.
NOTE
If belts are not adjusted correctly, perform steps 7 thru 13.
7
Loosen four bolts.
8
Loosen two adjusting screw locknuts.
9
Turn adjusting screws equally to adjust belt tensioner assembly.
10
Check adjustment (steps 1 thru 6).
11
Tighten adjusting screw locknuts.
12
Tighten four bolts.
13
Check adjustment after 2 hours of operation. Adjust as required. Check again after 2 more hours of operation.
14 Install housing (subpara e).
e.
Housing Installation
NOTE
Steps 1 thru 4 are performed only when replacing entire V-belt housing.
1
Install rear housing. Install five mounting screws and lockwashers.
2
Connect safety shutoff cord spring to rear housing.
3
Install throttle control and KILL START lever (para 2-87).
WARNING
To prevent electric shock, make sure battery is disconnected before performing this procedure.
4
Connect three wires to start switch. Remove tags.
2-213
