TM 10-4610-229-24
2-82. PILLOW BLOCK REPLACEMENT/REPAIR (CONT)
2 Loosen two bolts.
3 Remove bearing brackets from shaft.
c.
Assembly
1
Install bearing brackets. Tighten two bolts.
2
Install grease fittings.
d.
Installation
1
Install pillow block, two brackets, four washers, and bolts.
2
Tighten two screws.
3
Adjust V-belts (para 2-81).
2-83. HIGH PRESSURE PUMP ENGINE REPLACEMNT
This task covers:
a.
Removal
b.
Installation
INITIAL SETUP
Use With
Equipment
Condition
High Pressure Pump Assembly
Para
Condition Description
Tools
2-15
Battery cables removed.
2-16
Batteries removed.
Common No. 1 Organizational
2-77
Power cable assembly
Maintenance Automotive
removed.
Maintenance and Repair Shop
2-98
Coolant drained.
Equipment, item 11, appendix B
2-87
Engine start switch,
Basic Field Maintenance
KILL START lever, and
Automotive Maintenance and
throttle control
Repair Shop Equipment, item 20,
removed.
appendix B
2-85
Silencer removed.
Lifting Device, item 13,
2-106
Power takeoff removed.
appendix B
2-21
Fuel lines removed.
Sling, item 15, appendix B
2-215
