TM 10-4610-229-24
2-115. PRODUCT TUBE ASSEMBLY REPLACEMENT/REPAIR (CONT)
2
Remove O-ring, rubber grommet, metallic clip, and line nut
from other end. Discard metallic clips.
c. Assembly
NOTE
If tube is to be replaced, measure length of old
tube and cut new tube to same length.
1 Install two line nuts with thread facing ends of tube.
2 Install two metallic clips.
3 Install two rubber grommets with beveled side facing metallic clip.
4 Install two O-rings.
d. Installation
1 Install tube.
2 Tighten line nuts.
2-116. PRESSURE TUBE REPLACEMENT
This task covers:
a.
Removal (Tubes 11, 12, and 13)
e. Installation (All Other Tubes)
b.
Removal (Tubes 2 and 15)
f. Installation (Tube 2)
c.
Removal (Tube 2)
g. Installation (Tubes 2 and 15)
d.
Removal (All Other Tubes)
h. Installation (Tubes 11, 12, and
13)
INITIAL SETUP
Use With
References
Reverse Osmosis Block Assembly
2-112 Brine Spool Replacement
2-113 Product Spool Replacement
Tools
Equipment
General Mechanic's Automotive
Condition
Tool Kit, item 10, appendix B
Para
Condition Description
Lifting device, item 13,
appendix C
Reverse osmosis
Sling, item 15, appendix B
membranes removed.
(See TM 10-4610-229-10.)
Personnel Required
2-283