TM 10-4610-229-24
3-30. STARTER REPAIR (CONT)
6
Pull brushes, brush holders, and brush springs from housing.
7
Remove screws. Remove brushes.
8
Remove screw. Disconnect wire from connector.
9
Remove four nuts, lockwashers, and screws. Push solenoid connector into housing. Remove four pole shoes
and coil shunt.
10
Remove two bolts and lockwashers attaching solenoid to drive housing. Remove solenoid, plunger spring, and
gasket.
11
Remove nut and bolt from shift lever. Remove pin and plunger.
12
Remove two screws and lockwashers from plate.
13
Remove armature and shift lever from drive housing.
14
Remove shift lever from armature.
15
Remove bushing, retainer ring, stop collar, and dowel pin from drive assembly.
3-65
