TM 10-4610-229-243-57. GOVERNOR REPLACEMENT/REPAIR (CONT)5Drive bearing into governor housing to 1.702-1.714 in.6Drive bearing into governor housing to 2.380-2.390 in.7Screw plug in housing.8Install seal in governor housing with lip of seal toward outside.9Install torque spring assembly. Install lock and screws.10Install lever assembly. Install shaft in housing through lever.11Install lock and screw that hold lever to shaft.12Install speed limiter plunger, spring, and plug in housing.13Install O-ring seal on sleeve.14Install piston and sleeve in cylinder.15Install weight assembly on cylinder.16Install weight assembly retaining ring.17Install bearing and washers on sleeve.18Install bearing and washer retaining ring.19Install sleeve assembly on cylinder and weight assembly.20Install bolt in seat.21Install washers and spring in seat.22Install seat on valve. Install retaining pin. Install retaining ring.d. Installation1Install the cylinder/weight assemblies on injector pump housing. Be sure groove in piston is engaged in groovein shaft.2Install lock and three screws. Tighten screws. Bend tab on lock. Install washer.3Install spring, wave washer, washer, wave washer, and seat.3-154
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
