TM 10-4610-229-24
3-57. GOVERNOR REPLACEMENT/REPAIR (CONT)
3
Remove screw and idle screw housing cover and gasket. Discard gasket.
4
Remove two screws. Remove governor shaft cover and gasket. Discard gasket.
WARNING
Spring is under pressure in stop/run housing. Caution must be taken in removing cover. Injury to
personnel could result.
5
Remove four bolts. Remove front stop/run housing cover, gasket, and spring. Discard gasket.
6
Remove five bolts. Remove governor housing rear cover and gasket.
7
Remove two bolts, washers, gasket, rear stop/run housing cover, and stop/run housing.
8
Remove two bolts from lock. Remove lock.
9
Remove fuel shutoff lever.
10
Remove two idle screws.
11
Remove shaft stop collar screw. Remove collar and spring.
12
Remove governor housing mounting screws. Remove governor housing from injection pump.
13
Remove seat, wave washer, washer, wave washer, governor spring, and washer.
14
Straighten tabs on lock.
15
Remove three mounting screws, lock, and weight assembly from shaft.
3-151