TM 10-4610-229-24
2-15. BATTERY CABLE REPLACEMENT/REPAIR (CONT)
4
Loosen remaining battery terminal nuts. Disconnect battery cables.
5
Cut tie wraps as needed to remove cables.
6
Remove nut and lockwasher from starter. Remove cable.
7
Remove nut, washer, and cable from battery mounting plate.
b.
Repair
1
Cut off defective end that is to be replaced.
2
Strip 1/2-inch insulation from wire.
3
Heat new connector to be installed. Fill with solder.
4
Insert wire into connector. Let cool.
c.
Installation
Raw Water Pump and Boost Pump Assemblies
WARNING
· To prevent injury to personnel from electric shock, be very careful when connecting battery
cables.
· Fumes from battery acid may cause explosion. To prevent explosion, keep sparks and open
flame away from battery.
1
Install positive battery cable to starter. Install nut and lockwasher.
2-39