TM 10-4610-239-24
TM 08580B-24/3
REMOVAL.
a. Cut all wire ties
NOTE
Note routing of wiring harness.
b. Remove nut (1), screw (2), and lockwasher (3). Spread open and remove clamp (4). Discard lock
washer.
NOTE
Tag all wires before removal
There are multiple wires with terminal lugs at end. One is shown.
c.
Remove screw (5) and remove wire lug (6). Install screw in place.
d. Remove wiring harness (7).
INSPECTION.
NOTE
Refer to paragraph 3-39 for repair.
a. Inspect wiring harness for cracked, cut, or burned wires. Tag damaged wires.
b. Inspect terminals for good connection. Tag damaged wires.
c.
Check for continuity on all wires. Tag faulty wires.
INSTALLATION.
a. Route wiring harness (7) as noted during removal.
b. Install wire lug (6) as tagged in removal procedure.
c.
Install Screw (5).
d. Position clamp (4) and install screw (2), new lockwasher (3), and nut (1).
e. Install wire ties on wiring harness (7).
3-177
