TM 10-4610-310-14
0009 00
SETUP continued
27. Interconnect two sections of potable water hose (white) together.
28. Connect one end of potable water hose (white) to the chemical module outlet. See Figure 1 and Figure 13.
29. The other end of these two potable water hoses (white) will be connected to the product tank once the water
quality has been established.
30. Route the power electrical cable 8 (purple) from the chemical module and connect it to the control module
connection (J8).
WARNING
The 1000-gallon (3800-liter) fabric collapsible tanks are to be lifted by at least two personnel.
Do not attempt to lift any tank with less than two personnel. Injury to personnel may result.
31. Remove and setup the 1000-gallon (3800-liter) product tank in a suitable, level location where it will not be
subject to "creeping" or unintentional movement.
32. Unpacking the product tank is the same as settling tank. See WP 0008 00.
33. Make sure the product water tank inlet connection is set up within 20 feet (6.1 meters) from the chemical
injection/cleaning module. See Figure 1, Figure 14.
PRODUCT WATER
TANK INLET:
CONNECTION (AA)
2-INCH FEMALE
CAMLOCK
Figure 14. 1000-Gallon Collapsible Fabric Product Tank.
34. Connect the product inlet spool piece to the product water tank T3 connection (AA). See Figure 15.
CAUTION
Damage to low-pressure rupture disc may result if the unit is operated while the ball valve V49
on the inlet spool piece is closed.
35. Make sure that ball valve V49 on the inlet spool piece is open. See Figure 15.
