TM 10-4610-310-14
0037 00
CLEANING AND LUBRICATION
Proper cleaning and lubrication can aid in avoiding possible problems or trouble. Make it a habit to do the
following:
CAUTION
Follow all cleaning and lubricating instructions carefully. Failure to do so can result in damage
to equipment.
1. Expose Contamination Avoidance Covers (CAC) to fresh air during semiannual service.
2. Reduce interval as required in a rainy climate. Do not stow CACs when wet.
CAUTION
All hose connections must be clean. Dirt or debris may be ingested into the piping system. Failure to follow this
precaution may render the solenoid valves on the UF module inoperable. Failure to follow this precaution may
result in damage to equipment.
3. Maintain ends of all hoses and fittings clean. Use dust plugs/caps to prevent contamination of internal
surfaces of hoses and fittings.
4. Maintain diesel engines in high-pressure pump module and 3kW Tactical Quiet Generator (TQG) set.
Ensure air inlet filters are clean and oil is changed at scheduled intervals for the engines.
5. Maintain surfaces and fittings free of trash and contaminates on collapsible fabric water tanks. Make sure
zipper in top of product water tank T3 is clean and works properly.
6. When using water to clean the 3kW TQG set and high-pressure pump module, always cover all air ducts
and exterior ports with waterproof material. Cover receptacles, fuel fittings, control module assembly, and
outputs. Use water pressure and volume similar to household water pressure (50 psi maximum). After
cleaning, allow components to air dry. Do not use compressed air or run engines to decrease drying time.
Remove all waterproof material from ducts and other components before starting any component.
7. Keep indicators and switches on the control module assembly free of dirt and trash and dry.
8. Refer to TM 10-6116-639-13 for lubrication instructions and PMCS procedures for the 3kW TQG set.
PREVENTIVE MAINTENANCE CHECKS AND SERVICES
All PMCS will be done according to the periodicities outlined in Table 1. This table is provided so that the LWP
equipment can be maintained in good operating condition and ready for use.
NOTE
Operator will inspect for damaged or missing items while performing checks in walk around sequence
* - Performed at unit maintenance level or higher.
B Before, D During, A After, W - Weekly
0037 00-3
