TM 10-4610-310-14
0037 00
Table 1. Preventive Maintenance Checks and Services.
ITEM TO BE
EQUIPMENT
ITEM NO.
INTERVAL MANHOUR CHECKED OR
PROCEDURE
NOT READY/
SERVICED
AVAILABLE IF
Inspect general appearance of LWP.
Observe labels and the condition of the
paint. Inspect for rust, especially on
weldments.
1.
Before
General
Inspect for water leaks: loose or
missing bolts, screws, nuts, and hoses.
Inspect gaskets. Inspect for loose or
broken cable connections.
Inspect tools and Basic Issue Item (BII)
and Components of End Item (COEI)
boxes. Make sure tools and equipment Tools or
2.
Before
Tools and equipment are in good shape, clean, are
equipment not
accounted for, and in proper place.
available
Boxes close properly and are not
damaged.
Observe vent and drain lines
3.
Before
Vent and drain lines
connections.
Remove oil, grease, mud, chemical
spills, and other matter from all parts of
LWP.
Inspect for damaged or bent frames,
Damage that
Module frame and
4.
Before
loose mounting bolts, and missing or
would prevent
equipment
broken tie downs and frame pins.
operation
Inspect cross members for cracks and
breaks. Tighten loose mounting bolts.
Report trouble to unit maintenance.
Inspect for broken glass. Observe for
Gauges and flow
loose mountings and tube connections.
5.
Before
indicators
Report broken gauges and flow
indicators to unit maintenance.
UF cartridges/RO
Inspect for leaky gaskets and loose
6.
Before
pressure vessels
mountings. Notify unit maintenance
Inspect for leaks. Observe for hose or
Damaged items
Hoses, piping,
pipe blockages and parts are cracked
prevent
tubing, fittings,
7.
Before
or broken. Tighten loose connections.
operation or
strainers, and nozzle Replace damaged hoses and parts.
creates safety
hazard.
Damage that
Inspect all electrical cables, hoses,
would prevent
piping for cuts, wear, nicks, kinks,
8.
Before
UF module
operation or
breaks, exposed wires, etc. Inspect for
creates safety
loose fasteners and fittings.
hazard.
0037 00-4
