TM 10-4610-310-14
0093 00
ASSEMBLY
Before assembly, ensure that all the gasket, seals and o-rings are serviceable. Ensure that all mating surfaces
are clean and free of old seal material. Replace old locknuts with new ones.
Oil Filter
1. Refer to Figure 1 for this procedure section.
2. Rub a light coat of clean engine oil on the o-ring (4) and install on the new oil filter (1).
3. Slide oil filter into the engine block (2) and secure using bolt (3).
4. Refill engine oil. See WP 0094 00.
Fuel Strainer
1. Refer to Figure 2 for this procedure section.
2. Remove the fuel cap (1) and place the strainer (3) inside the fuel tank (4).
3. Install the fuel cap (1) and gasket (2).
1. Install the gasket (10) onto the fuel filter (11).
Figure 6. Fuel Filter Assembly.
2. Install the fuel filter onto the plate (9).
3. Install the o-ring (12), fuel filter (11), gasket (10), and plate (9) into the fuel tank (13). Secure with screws
(8).
4. Install the seal (7) on the fuel cock (6).
5. Install the fuel cock (6) on the plate (9) and secure with locknut (5).
6. Install the fuel hose (3) on the fuel cock (6).
7. Tighten hose clamp (4).
END OF WORK PACKAGE
