TM 10-4610-310-14
0102 00
Installation
1. Install receptacle into cutout on side of control module.
2. Install jam nut on front of receptacle. Tighten securely.
3. Install safety wire through holes in jam nut.
4. Insert wire contacts into receptacle with pin remover/installer. Observe number tags and prior notes for
proper connection.
GROUNDING CONNECTOR
Removal
1. Remove two capscrews, four flat washers, two lock washers, and two hex nuts from cable connector on
bottom of control module mounting rack. See Figure 4.
2. Remove cable connector from control module. See Figure 7.
WASHER & NUT
WASHERS
NUT
SCREW
SCREW
(2 PLACES)
GROUNDING
CONNECTOR
RECEPTACLE
CONNECTOR
Figure 7. Ground Connector/Receptacle Connector.
Installation
1. Install cable connector on bottom of control module.
2. Install two capscrews, four flat washers, two lock washers, and two hex nuts through cable connector.
Tighten securely.
RECEPTACLE CONNECTOR (J14)
Removal
1. Connector located under left corner of control module assembly.
2. Tag all wires on pushbutton connections receptacle connector.
3. Remove 22 wire contacts from receptacle connector. See Figure 7.
4. Remove two screws, lock washers, and nuts from receptacle connector.
5. Separate receptacle connector from 50-position plug connector. Remove from control module.
Installation
1. Install 50-position plug connector in cutout under control module.
2. Assemble receptacle connector to 50-position connector.
3. Install two screws, lock washers, and nuts on receptacle connector.
4. Connect 22 wire contacts to receptacle connector. Observe tags for proper connection.
