TM 10-4610-310-14
0122 00
Camshaft Oil Seal Replacement
1. Insert camshaft oil seal into crankcase cover until flush with end of the crankcase.
Crankcase Cover Installation
1. Position the crankcase cover over shaft gears in the engine block.
2. Align the crankcase cover with two guide pins, upper and lower.
3. Install 13 bolts through crankcase cover and engine block.
4. Be sure to tighten all 15 screws on the crankcase cover 1079 to 1275 N-cm (8 to 9.4 lb-ft).
CAUTION
Do not over tighten bolts. Use diagonal pattern for tightening to prevent warping cover.
5. Tighten bolts in diagonal sequence. See Figure 3.
10
12
5
3
1
8
7
13
4
2
9
6
11
Figure 3. Tightening Crankcase Cover.
6. Tighten stiffener bolt (11) between 1960 to 2256 N-cm (14.5 to 16.6 lb-ft). See Figure 1.
END OF WORK PACKAGE
