TM 5-3800-205-10-2
TROUBLESHOOTING PROCEDURES - CONTINUED
0011 00
Table 1. Troubleshooting Procedures - Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
ELECTRICAL SYSTEM - CONTINUED
11. Stoplights Do Not Operate When Brake
2. Check lights for separated
2. Reconnect connectors, if
Pedal is Pressed - Continued.
connections/damage.
required. If any damage to
lights is found, notify Unit
Maintenance. If problem still
exists, go to test step 3.
NOTE
A thirty (30) minute cool down time may be required before circuit breaker automatically resets.
3. Check that circuit breaker is
3. If circuit breaker does not
not tripped.
automatically reset, notify
Unit Maintenance.
1. Select STOP LIGHT or SER.
12. Taillights Do Not Come On.
1. Ensure STOP LIGHT or SER.
DRIVE. If problem still exists,
DRIVE function has been
go to test step 2.
selected on military light
switch.
2. Check electrical connections
2. Reconnect connectors, if
at hitch area.
required. If problem still
exists, go to test step 3.
NOTE
A thirty (30) minute cool down time may be required before circuit breaker automatically resets.
3. Check that circuit breaker is
3. If circuit breaker does not
not tripped.
automatically reset, notify
Unit Maintenance.
13. Water Distributor Control Panel Light
1. Check for burned out bulb.
1. If bulb is burned out, notify
Unit Maintenance. If bulb is
Does Not Come On.
okay, go to test step 2.
2. Reconnect
connector
if
2. Check connection of electrical
required. If problem still
harness
at
receptacle
exists,
notify
Unit
connector on side of cab.
Maintenance.
1. Check for burned out bulb(s).
1. If bulb(s) is burned out, notify
14. Water Distributor Control Panel Water
Unit Maintenance. If bulb(s) is
Level Green/Red Panel Indicator
okay, go to test step 2.
Lights Do Not Come On.
2. Reconnect
connector
if
2. Check connection of electrical
required. If problem still
harness
at
receptacle
exists,
notify
Unit
connector on side of cab.
Maintenance.
