TM 5-3800-205-23-3
WORK LIGHT MAINTENANCE - CONTINUED
0006 00
WORK LIGHT ASSEMBLY REMOVAL
NOTE
This procedure is for both work lights. Left work light is shown.
1.
Disconnect harness connector (12) from work light receptacle connector (13).
2.
Remove bolt (4), two washers (15), and nut (3), and remove work light assembly (14) from mount bracket (16).
3.
Inspect mount bracket (16) for damage. If damaged, remove bolt (17), washer (18), and bracket from fender.
14
13
12
16
3,4,15
17,18
WORK LIGHT ASSEMBLY INSTALLATION
NOTE
Mount bracket should be positioned to ensure good visibility to rear and sides of water distributor.
1.
If removed, position mount bracket (16) on fender and secure with washer (18) and bolt (17).
2.
Position work light assembly (14) on mount bracket (16) and secure with bolt (4), two washers (15,) and nut (3).
3.
Connect harness connector (12) to work light receptacle connector (13).
4.
Place battery disconnect switch in ON position (TM 5-3800-205-10-2).
5.
Check operation of work light (TM 5-3800-205-10-2).
END OF WORK PACKAGE
0006 00-4
