TM 5-3800-205-23-3
WORK LIGHT MAINTENANCE - CONTINUED
0006 00
LENS AND LAMP INSTALLATION
NOTE
Outer lip of bezel should overlap work light edge.
1.
Install work light (5) in bezel (2).
CAUTION
Route white wire so that it is not pinched under lamp retainer. Failure to do so could result in damage.
2.
Install lamp (7) into work light receptacle and route white wire (9). Secure lamp with lamp retainer (8).
3.
Connect wire (11) to work light (5).
4.
Connect wire (10) to white wire (9).
NOTE
Install bezel and work light with word TOP facing up.
5.
Install bezel (2) and work light (5) in housing (6).
6.
Install two clamps (1) on bezel (2).
7.
As required, adjust work light assembly position and tighten nut (3) on bolt (4).
8.
Place battery disconnect switch in ON position (TM 5-3800-205-10-2).
9.
Check operation of work light (TM 5-3800-205-10-2).
1
2
3,4
0006 00-3
