TM 5-4610-223-12
b.
Cleaning. Clean reflector glass and mounting frame with drycleaning solvent.
c.
Inspection. Inspect reflectors for broken glass and damaged mounting frame.
d.
Removal.
(1)
Remove two screws (3, fig. 4-32) and washers (2) securing reflector (1) to van body.
(2)
Pry reflector from van body with a screwdriver.
(3) Replace damaged reflectors.
e.
Installation.
(1)
Position reflector (1, fig. 4-32) on van body with screw holes of reflector aligned with those of van body.
(2)
Secure reflector to van body with two screws (3) and washers (2).
4-36. HUNTER HEATER.
a.
Removal.
(1)
Turn fuel shutoff vale (1, fig. 4-33) to closed position.
(2)
Disconnect attaching nuts, and remove fuel line (2) and overflow line (3) from heater (4).
(3)
Disconnect electrical power cable (5), fuel pump cable (6) and thermostat cable (7) from heater (4).
(4)
Remove exhaust stack (fig. 3-7) and attaching collar from rear of heater (4).
(5)
Remove attaching screws (8) and heat duct (9) from heater (4).
(6)
Remove screws (10) and washers (11) securing heater to mounting platform and bracket (12).
(7)
Withdraw heater from exhaust stack opening and remove heater from van.
(8)
Replace a defective heater.
b.
Installation.
(1)
Position heater (4, fig. 4-33) on mounting platforms (12) and align it with exhaust stack opening.
4-74