TM 10-4610-239-24
TM 08580B-24/3
DISASSEMBLY. (Cont)
a. Remove 10 nuts (1) and flat washers (2) from studs on pressure tub (3).
e
b. Remove two end cap puller bolts (6) from both end cap assemblies (4).
c.
Screw four end cap puller bolts (6) into threaded holes in end cap (4) until end cap assembly is separated from
the pressure tube (3) and remove end cap assembly (4).
d. Remove retaining ring (7) and discard.
e. Remove permeate port (8) and end connector (9). Separate end connector (9) from permeate port (8).
f.
Remove two O-rings (10) and (11) from end connector (9) and separate end plate (4) from sealing plate (5.)
g. Remove two O-rings (12) and (13) from sealing plate (5).
h. Remove adapter (14) and O-ring (15) from permeate port (8).
i.
Remove retaining ring (16) from concentrate port (17). Discard retaining ring. Remove concentrate port (17).
j.
Remove filter elements. Refer to TM 10-4610-239-10.
CLEANING.
a. Using strong soap solution, clean end plate and end plug.
b. Clean permeate port, concentrate port, nuts, lockwashers, and studs.
INSPECTION.
a. Inspect end connector and O-rings for damageor deformity. Replace as required.
b. Inspect end plate for damage, excessive wear, and serviceability. Replace as required.
c.
Inspect end plug, permeate port, and concentrate port for wear, proper fit, and serviceability.
Replace as
required.
d. Inspect R.O. pressure tube and studs for damage. Replace as required.
2-216
