ARMY TM 10-4610-309-14
MARINE CORPS TM10802A-14/1
0007 00
TACTICAL WATER PURIFICATION SYSTEM (TWPS)
PREPARATION FOR USE AND INSTALLATION INSTRUCTIONS
SET-UP OPERATION UNDER USUAL CONDITIONS
3. Attach the top, front, and side edges of the wall to the top panel as follows:
a. Lift the fabric wall by the top, front edge.
b. Secure the hook and loop strip on the top edge of the wall to the hook and loop strip on
the top panel.
c. Loop each of the straps through its corresponding footman loop on the top panel and
secure each strap in its buckle.
4. Two people raise the top panel with the attached fabric wall into position.
5. The third person inserts the pins in the top panel supports to secure the top panel.
6. Attach the side edge of both end walls as follows:
a. Match and smooth the hook and loop strip on the side edge of the wall side flap to the
hook and loop strip on the TWPS frame.
b. Loop each side wall strap through its corresponding footman loop on the end panel and
secure the strap in its buckle.
7. Attach the bottom edge of both wall side flaps to the bottom panel as follows:
a. Fit the opening in the wall side flap for the support leg over the support leg.
b. Match and smooth the hook and loop strip on the bottom edge of the wall side flap to the
hook and loop strip on the bottom panel.
c. Loop both of the straps on the bottom of one wall side flap through its corresponding
footman loop on the bottom panel and secure each strap in its buckle.
8. Attach the bottom, front edge of the wall to the deck as follows:
a. Fit the openings in the wall front for the support legs over the support legs.
b. Fit the sleeves in the wall front for the raw water hose and the waste-water hose over the
hoses. Close the sleeves snug around the hoses using the hook and loop strip at the
bottom of the sleeve and with the tie cord.
c. Match and smooth the hook and loop strip on the bottom edge of the wall to the hook and
loop strip on the bottom panel.
d. Loop each of the straps on the bottom, front edge of the wall through its corresponding
footman loop on the bottom panel and secure each strap in its buckle.
EXTENDED DISTRIBUTION SYSTEM SET-UP (A-TWPS)
Deploy the extended product water distribution system equipment as follows (see Figure 13):
WARNING
Two person lift. Two people are required to safely lift the product water
distribution water tanks. Lift with your legs, not your back. Failure to observe this
warning may result in back injury.
Three person lift. Three people are required to lift Diesel-Driven Distribution Pump
P-8. Lift with your legs, not your back. Failure to observe this warning may result
in back injury.
1. Position Product Water Distribution Tanks T-5, T-6, and T-7 and Product Water Distribution Pump
P-8 as follows:
a. Place the distribution tanks in their rough locations. One of the three tanks must be
within 40 ft. of the TWPS product water outlet and within reach of the distribution hoses
that are set out for connection to the tanks in the standard distribution system.
b. Unfold the ground cloth from around each tank and unfold each tank on its ground cloth.
0007 00-21
