TM 10-4610-310-14
0085 00
INSPECTION
1. Inspect all threads for damage.
2. Inspect all o-rings for serviceability.
3. Inspect the check valve by removing the union (1) and checking the rubber diaphragm inside. See Figure
11.
4. Inspect all piping components for blockage.
INSTALLATION
Before installing any spool pieces into the module, the following tasks should be accomplished.
1. All the threads should be wrapped with at least four layers of anti-seize thread tape.
2. Ensure all the equipments involved are clean to avoid introducing unwanted matter into the module.
CAUTION
Care must be taken not to cross thread piping. Never over tighten. Damage to equipment may result.
After installation of the spool pieces the necessary camlock fittings, dust plugs and dust caps for the fittings must
be installed if taken off.
UF FEED PIPING
1. Refer to Figure 2 for this piping.
2. Mount the piping in its location.
3. Tighten the unions (1).
4. Install the U-bolt (4) and fasten the lock nuts (1) washers (6) to the U-bolt (4).
5. Install the differential pressure gauge tubing to tee fitting (2).
6. Install the feed pressure gauge tubing to tee fitting (5).
7. Install the temperature gauge (3) if necessary.
8. Install support washer (11) and a new 30-mesh screen (10) if removed.
UF TANK INLET PIPING
1.
Refer to Figure 3 for this piping.
2.
Mount the piping in its location.
3.
Tighten the union (1).
4.
Install the U-bolt (7) and fasten the lock nuts (8) washers (9) to the U-bolt (7).
5.
Fasten the solenoid valve with screws (10), lock washers (11) and washers (12).
6.
Install the solenoid valve coil.
7.
Install the flow controller (2), nipple (3), flow indicator (4), filtrate valve (5) and fitting (6) on the piping as
necessary.
LEVEL SWITCH PIPING
1.
Refer to Figure 4 for this piping.
2.
Mount the piping in its location.
3.
Tighten the union (1).
4.
Install the U-bolt (3) and fasten the lock nuts (6) washers (5) to the U-bolt (3).
BACKWASH INLET PIPING
1.
Refer to Figure 5 for this piping.
2.
Mount the piping in its location.
3.
Tighten unions (1,2, and 3).
4.
Install tubing on tee fitting (7).
5.
Install the U-bolt (4) and fasten the lock nuts (10) washers (11) to the U-bolt (4).
0085 00-8
