TM 5-3800-205-23-3
HYDRAULIC HOSES REPLACEMENT (WATER TANK-TO-HYDRAULIC MOTOR)
THIS WORK PACKAGE COVERS
Removal, Installation
INITIAL SETUP
Materials/Parts - Continued
Maintenance Level
Strap, tiedown (Item 38, WP 0044 00)
Unit
Tag, marker (Item 39, WP 0044 00)
Tools and Special Tools
Seal, O-ring (2)
Tool kit, general mechanic's (Item 33, WP 0045 00)
References
Shop equipment, common no. 1 (Item 24, WP 0045
TM 5-3800-205-10-2
TM 5-3800-205-23-1
Materials/Parts
Equipment Condition
Cap set, protective (Item 5, WP 0044 00)
Hydraulic hoses disconnected from quick discon-
Oil, lubricating (Item 24 or 29, WP 0044 00)
nect fittings at top of tank (WP 0024 00)
Rear steps removed (WP 0018 00)
Rag, wiping (Item 31, WP 0044 00)
WARNING
Do NOT disconnect or remove any hydraulic system line or fitting unless engine is shut down and
hydraulic system pressure has been relieved. Tighten all connections before applying pressure. Escap-
ing hydraulic fluid under pressure can penetrate the skin, causing serious injury.
At operating temperature hydraulic oil is hot. Allow hydraulic oil to cool before disconnecting any
hydraulics. Failure to do so could result in injury.
Hydraulic fluid is very slippery. Immediately wipe up any spills. Failure to follow this warning may
result in injury to personnel.
CAUTION
Wipe area clean around all hydraulic connections prior to disconnecting. Cap or plug all openings after dis-
connecting. Contamination of hydraulic system could result in equipment failure.
NOTE
Tag hydraulic hoses after disconnecting, to ensure correct installation.
Remove tiedown straps as required and discard. Use new tiedown straps on installation to ensure
hydraulic hoses are properly supported.
Steps to replace hydraulic hoses between water tank bulkhead connectors and water pump hydraulic
motor are the same. Right-side hydraulic hose is shown in this procedure.
Use a suitable container to catch fluid. Dispose of fluid according to local regulations and mandates.
