TM 10-4610-229-243-74. CRANKSHAFT REPLACEMENT (CONT)12Lubricate the cap bearing halves with engine oil (MIL-L-2104).13Repeat steps 8 thru 10.NOTE•Thrust bearing must be installed with side marked BLOCK SIDE toward cylinder block.•End play is controlled by the thrust bearings of no. 4 main bearing.14Install thrust bearings for no. 4 main bearing.15Connect dial indicator to a machined surface of crankcase.16Check end play of the crankshaft. End play with new bearings should be 0.006-0.022 in. Maximum end playwith used bearings is 0.035 in.17Install pistons (para 3-76).18Install oil pump (para 3-72).19Install flywheel (para 3-70).20Install timing gear cover (para 3-68).21Install front and rear seal and wear sleeve (para 3-79).22Install fuel injection pump (para 3-52).3-192
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
