TM 10-4610-232-34
2-22. MAIN CONTROL PANEL UPPER EXTERIOR PANEL. This task covers:
a. Inspection.
b. Disassembly.
c. Repair.
d. Reassembly.
e. Adjust.
INITIAL SETUP.
Tools, see TM 10-4610-232-12, Appx B,
Equipment Condition:
Sec Ill, Ref Code (No.):
Testing and Adjusting: ROWPU operating normally
Tool Kit, General Mechanics Automotive (1)
Inspection, Disassembly and Reassembly: ROWPU
Flowmeter, Auxiliary (7)
shutdown. Generator shutdown.
Materials/Parts:
General Safety Instructions:
Lamps (Appx B, Sec II, Item 49)
Markers, Wire (Appx B, Sec II, Item 54)
WARNING
Terminals, Ring (Appx B, Sec II, Item 70)
Observe specific Warnings in the text.
Varnish (Appx B, Sec II, Item 73)
Suitable Tags
Lockashers (TM 10-4610-232-24P)
Washers (TM 10-4610-232-24P)
WARNING
Do not wear watches, rings or dog tags when working on main control panel.
NOTE
Tag all wires before disconnecting
NOTE
Main circuit breaker (CB1) has to be in the OFF position and the lower exterior panel
door must be unlatched and opened before upper exterior panel door can be opened.
INSPECTION.
WARNING
Make sure electrical power is disconnected before working on unit. Failure to do so
could result in serious injury or death from electrical shock.
a. Unlatch door latches and open upper exterior panel door.
b. Visually check components for signs of damage or looseness.
c. Check for loose or damaged wires.
DISASSEMBLY.
WARNING
Make sure electrical power is disconnected before working on equipment. Failure to
do so could result in serious injury or death from electrical shock.
a. Refer to Figure 2-25, sheet 1 and disassemble 29 indicator lights as follows:
(1) Open control panel door.
2-119
