TM 10-4610-240-10
TM 08580C-10/1
T.O. 40W4-13-21
h.
NOTE
Remove puller bolts (11, figure 3-1) from end cap (10).
(1)
Lubricate O-rings with O-ring lubricant from Storage Box No. 2.
NOTE
There is a smaller and a bigger sized O-ring on the end connectors. The side of the end connector which
will fit on end of R. O. element has a lip on the inside. This side of end connector has the bigger O-ring.
The interconnector O-rings are the same size as the bigger end connector O-rings.
(2)
Install O-rings (1) and (3) in end connectors (2) and two O-rings (3) in interconnector (5).
FIGURE 3-5. R.O. VESSEL (EXPLODED VIEW)
WARNING
Some R. O. elements are packaged in sealed plastic bags with the protective chemical formaldehyde,
which is poisonous; avoid fumes and keep away from eyes and mouth. Handle with extreme care. After
handling, wash hands thoroughly with soap and water.
CAUTIONS
After removing R.O. element from sealed bag, take care to keep element clean.
Failure to do so will bring dust and dirt into R.O. elements and cause early element failure.
Do not expose elements to direct sunlight for an extended period of time.
Sunlight may damage the elements.
3-20
