TM 10-4610-310-14
0120 00
DISASSEMBLY - continued
2. Remove lock nut (6) from the adjustment screw (2).
3. Remove adjustment screw (2) only if necessary.
4. Remove rocker arm (3) and wear cap (7).
Push Rods
1. Pull out push rods from cylinder head. Place on clean surface. See Figure 3.
2. Identify and separate the push rods for intake and exhaust valves.
Cylinder Head
1. Remove two cap nuts (1) from cylinder head and two nuts (2). See Figure 2.
2. Remove four washers (3).
3. Remove the cylinder head (7) from the engine block (6).
4. Pull up over four mounting studs (4).
5. Remove head gasket (5).
Figure 2. Removing Cylinder Head.
