TM 10-4610-229-24
3-54. INJECTION PUMP REPLACEMENT (CONT)
10
Slowly turn lever toward FUEL-ON until test light has a minimum light output.
NOTE
In this position, rack stopcollar is just making contact with torque spring or stop bar.
11
Read measurement on dial indicator. Reading should be 0.180 in. If adjustment if correct, go to step 15.
12
Remove two screws. Remove governor shaft cover.
13
Loosen adjusting screw locknut.
14
Turn adjusting screw to obtain reading of 0.180 in. on dial indicator.
15
After adjustment is completed, torque locknut to 6-12 ft lb.
16
Install governor shaft cover. Tighten screws.
17
Disconnect circuit tester.
18
Remove dial indicator and bracket group.
19
Install stop, gasket, spacer, and lockwasher. Install two screws.
3-139